Dinosaur Electric Ignitor Boards Fan Control FAN 50 PLUS PINS; Replaces Dinosaurs Earlier Small And Large Fan Boards
Dinosaur Electric Ignition Control Circuit Board; Replaces Dinosaurs Earlier Small And Large Fan Boards; Can Also Be Used To Replace The Present Fan Control Ignitor Boards Being Used By Suburban\ Atwood\ Hydroflame
The FAN 50 Plus Pins is designed to replace the new Suburban® and Atwood® / HydroFlame® Fan Control boards as well as maintain backward compatibility with the Fan 50 Plus, and UIB Fan Control boards which have been available since 1994. This board can also be used to upgrade older furnaces to add the Fan Control feature. The basic purpose of a Fan Control Ignitor Board is to shut the fan motor off if the board fails to sense a flame after the third ignition try. Thus, battery drain is reduced and the needless blowing of cold air is eliminated.
- Used To Upgrade Older Furnaces To Add The Fan Control Feature
- Shuts The Fan Motor OFF If The Board Fails To Sense A Flame After The Third Ignition Try
- Battery Drain Is Reduced And The Needless Blowing Of Cold Air Is Eliminated
- Compatible With The Fan 50 Plus And UIB Fan Control Boards
- Limited 3 Year Warranty
Specifications of Dinosaur Electric Ignitor Boards Fan Control FAN 50 PLUS PINS; Replaces Dinosaurs Earlier Small And Large Fan Boards | |
Compatibility | Replaces Dinosaurs Earlier Small And Large Fan Boards |
Length (IN) | 4-1/4 Inch |
Voltage | 12 Volt |
Width (IN) | 3.35 Inch |
No questions found. Be the first?
There are no reviews for this product.